DURKOPP ADLER 610-10 Service Instructions Manual page 127

Troubleshooting
Code Type
1056 Error
1058 Error
1060 Error
1061 Error
1062 Error
1120 Error
1203 Information
1302 Error
1330 Error
2102 Error
2103 Error
2121 Error
2122 Information
Service Instructions 610-10/630-10 - 01.0 - 12/2016
Possible causes
Sewing motor overtemperature:
• Sewing motor not moving freely
• Sewing motor defective
• Control defective
Sewing motor speed greater than
setpoint:
• Reference switch defective
• Sewing motor defective
PowerParts
Sewing motor disturbance:
• Encoder defective
• Sewing motor defective
Sewing motor disturbance
(IDMA auto increment)
Software error:
• Parameter not initialized
Sewing motor:
Position not reached
Sewing motor current error:
• Sewing motor blocked
• Encoder cable not connected or
defective
• Encoder defective
Sewing motor not responding
X-axis stepper motor:
• Stepper motor not moving freely
or blocked
• Encoder cable not connected or
defective
• Stepper motor cable not
connected or defective
• Encoder defective
• Stepper motor defective
X-axis stepper motor step losses:
• Stiff mechanical movement or
blockage
X-axis stepper motor:
• Encoder plug (Sub-D, 9-pin) not
connected or defective
• Encoder defective
Magnet wheel search timeout
Remedial action
• Correct the cause of not moving
freely
• Replace the sewing motor
• Replace the control
• Replace the reference switch
• Replace the sewing motor
• Replace the control
• Switch off and on the machine
• Replace the encoder
• Replace the sewing motor
• Contact customer service
• Switch off and on the machine
• Perform software update
• Switch off and on the machine
• Perform software update
• Contact Customer Service
• Remove the blockage
• Check the encoder cable and
replace, if necessary
• Replace the sewing motor
• Switch off and on the machine
• Perform software update
• Contact Customer Service
• Remove the cause of the stiff
movement or blockage
• Check the encoder cable and
replace, if necessary
• Replace the encoder
If the stepper motor is not supplied with
current:
• Check the stepper motor cable and
replace, if necessary
• Replace the stepper motor
• Remove the cause of the stiff
mechanical movement or blockage
• Check the connection of the encoder
cable and replace, if necessary
• Check connection cables
• Check stepper motor for stiff
movement
125