Fig. 75: End position of the thread cutter (3)
⑦
⑧
(7) - Edge
5. If you move the piston rod (2) to its right end position, the edge (7) of
6. Loosen the nut (4) and set the end position of the cylinder accordingly
7. Tighten the nut (4).
8. Erect the machine head ( p. 14).
Order
Perform a cutting test while sewing for both the smallest and the largest
stitch length.
6) Thread advancing device for looper and needle thread
Fig. 76: Thread advancing device for looper and needle thread
①
(1) - Needle thread advancing device
(2) - Looper thread advancing device
82
the blade carrier and the edge (8) of the tabletop should be flush with
one another.
using the stop (3).
Individual settings
(8) - Edge
②
(3) - Stop
Service Instructions 610-10/630-10 - 01.0 - 12/2016
③