DURKOPP ADLER 610-10 Service Instructions Manual page 82

3) Thread clamping plate
Fig. 71: Thread clamping plate
(1) - Thrad clamping plate
The thread clamping plate (1) should hold the cut thread end gently in place
to ensure a secure seam beginning.
Important
If set too tight, the clamping plate may cause ruffing at the seam beginning.
4) Changing the thread cutter blade
Fig. 72: Changing the thread cutter blade
①
②
(1) - Blade carrier
(2) - Ball lever
(3) - Screw
To change the thread cutter blade:
1. Loosen the screw (3).
2. Remove the blade (4).
3. Insert the blade (4).
4. Tighten the screw (3).
80
①
⑤
③
(4) - Blade
(5) - Screws
Service Instructions 610-10/630-10 - 01.0 - 12/2016
Individual settings
④