DURKOPP ADLER 610-10 Service Instructions Manual page 72

To set the stroke height of the top feed:
1. Loosen the screw (1).
2. Move the bearing block (4) and set dimension X (71.5 mm).
3. Tighten the screw (1).
4. Relieve the rocker lever (5) by swinging it to the left.
Fig. 57: Setting the stroke height of the top feed (2)
(7) - Clamping hub
5. Loosen the screw (8) of the clamping hub (7).
Fig. 58: Hubhöhe des Obertransports einstellen (3)
(3) - Top feed foot
6. Rotate the stroke shaft (6).
Important
Do not set the stroke higher than necessary! The higher the stroke the
shorter the movement of the top feed on the feed dog.
7. Tighten the screw (8).
70
The top feed foot (3) should have a maximum stroke of 2 mm relative
to the throat plate (9).
Turn the stroke shaft (6) until the top feed has reached the required
stroke.
⑦
⑧
(8) - Screw
2 mm
(9) - Throat plate
Service Instructions 610-10/630-10 - 01.0 - 12/2016
Individual settings
⑧
③
⑨