DURKOPP ADLER 610-10 Service Instructions Manual page 126

Code Type
1004 Error
1005 Error
1006 Error
1007 Error
1008 Error
1010 Error
1011 Error
1012 Error
1051 Error
1052 Error
1053 Error
1054 Error
1055 Error
124
Possible causes
Sewing motor error:
• Incorrect direction of rotation
Sewing motor current error:
• Sewing motor blocked
• Encoder cable not connected or
defective
• Encoder defective
Sewing motor error:
• Max. speed exceeded
• Sewing motor cable defective
• Sewing motor defective
Error in the reference run
Sewing motor encoder error
Sewing motor synchronization
error:
• External synchronizer plug
(Sub-D, 9-pin) not connected
Sewing motor synchronization error
(Z pulse)
Sewing motor synchronization error • Replace the synchronizer
Sewing motor timeout:
• Cable to sewing motor
reference switch defective
• Reference switch defective
Sewing motor overcurrent:
• Sewing motor cable defective
• Sewing motor defective
• Control defective
Sewing motor overvoltage
Internal short circuit
Sewing motor overload (I²T):
• Sewing motor not moving freely
or blocked
• Sewing motor defective
• Control defective
Remedial action
• Replace the encoder
• Check plug assignment and change,
if necessary
• Check wiring in machine distributor
and change it, if necessary
• Test motor phases and check for
correct value
• Remove the blockage
• Check the encoder cable and
replace, if necessary
• Replace the sewing motor
• Switch off and on the machine
• Replace the encoder
• Perform reset
• Replace the sewing motor
• Contact customer service
• Replace the encoder
• Eliminate stiff movement in the
machine
• Replace the encoder
• Connect plug of external
synchronizer to control, use correct
connection (Sync)
• Replace the reference switch or
synchronizer
• Only required for machines with
transmission!
• Switch off the control, use
handwheel to turn and switch on the
control again
• If error is not corrected, check
encoder
• Replace the cable
• Replace the reference switch
• Replace the sewing motor cable
• Replace the sewing motor
• Replace the control
• Check the mains voltage
• Replace the control
• Remove the cause of the stiff
movement or blockage
• Replace the sewing motor
• Replace the control
Service Instructions 610-10/630-10 - 01.0 - 12/2016
Troubleshooting