Individual settings
5) End position of the thread cutter
Fig. 73: End position of the thread cutter (1)
(1) - Nut
(2) - Piston rod
To set the end position of the thread cutter:
1. Disconnect the machine from the compressed air supply.
2. Tilt the machine head ( p. 14).
3. Slide the piston rod (2) to the left end position.
4. Loosen the counternut (1) and turn the piston rod (2) until the position
Fig. 74: End position of the thread cutter (2)
(5) - Notch
Important
The point (6) of the movable blade should be approx. 0.5 - 1 mm below the
notch (5) of the counter blade.
The point (6) of the movable blade should be approx. 0.5 - 1 mm behind
the notch (7) of the counter blade.
Service Instructions 610-10/630-10 - 01.0 - 12/2016
①
②
depicted below has been reached.
⑤
(3) - Stop
(4) - Nut
⑥
(6) - Point
④
③
81