About Parameters; Parameter Types - Allen-Bradley 8720MC-RPS065 User Manual

About Parameters

Configure Parameters
Parameters are used to define characteristics of the 8720MC-RPS unit. To
program the unit for a specific application, you display the appropriate
parameter and make adjustments as required. This chapter provides
information on parameter types, detailed descriptions of each parameter, and
describes how to access, display, and modify parameters.
Topic
About Parameters
User Parameters
Factory Parameters
Default Parameter Settings
ATTENTION: Only qualified electrical personnel familiar with the
construction and operation of this equipment and the hazards involved
should adjust and operate this equipment. Read and understand this manual
in its entirety before proceeding. Failure to observe this precaution could
result in destruction of the equipment, severe bodily injury or loss of life.
Parameters break down into two types that can be used in the operation of the
8720MC-RPS unit.

Parameter Types

There are two types of parameters:
• User Parameters - These parameters can be adjusted or modified at any
time
• Factory Parameters - These parameters are initially set at the factory and
usually are not required to be adjusted or modified in the field
The factory parameters are protected by a password and the password must be
set to access these parameters. However, some parameters cannot be modified
during operation even though the password has been set.
Rockwell Automation Publication 8720MC-RM001K-EN-P - September 2018
7
Chapter
Page
85
88
89
97
85