8720Mc-Rps Powerup Sequence; 8720Mc-Rps Operation - Allen-Bradley 8720MC-RPS065 User Manual

Chapter 6 8720MC-RPS Startup and Operation
8720MC-RPS Powerup
Sequence

8720MC-RPS Operation

78
Follow these steps to apply power to the 8720MC-RPS unit.
1. Turn the RUN sequence signal OFF.
2. Turn the input power circuit breaker to the ON position.
3. Apply power to the 8720MC-RPS unit (see
4. Verify that the unit powers up properly without incident such as
abnormal sound or odor.
5. Verify that there is no input power voltage drop or short circuit.
6. Verify that the rating of the 8720MC-RPS unit matches the parameter
setting of the Unit Selection (F.001).
For more information on parameter F.001, refer to
on page 89.
This start-up procedure describes the minimum set of parameters. Your
application may require programming other parameters in addition to those
described in this start-up procedure. Refer to
on page 85 for a description of all parameters to verify whether you need to
program additional parameters.
In this publication, there are references to parameter names and the numbers
that identify them for the 8720MC-RPS unit. This publication uses the same
format shown on the display to refer to parameters:
U.nnn
F.nnn
where: nnn is a number
U designates User parameters
F designates Factory parameters
Rockwell Automation Publication 8720MC-RM001K-EN-P - September 2018
page 79).
F.001 Unit Selection
Configure Parameters beginning