Installing The Switch; Installing The Spinner - Seagull Models EDGE 540 Assembly Manual

www.seagullmodels.com
3x10mm(6pcs).

INSTALLING THE SWITCH.

Install the switch into the precut hole in the
side of the fuselage.

INSTALLING THE SPINNER.

1) Install the spinner backplate, propeller
and spinner cone. (spinner is not included).
The propeller should not touch any part
of the spinner cone. If it does, use a sharp
modeling knife and carefully trim away the
spinner cone where the propeller comes in
contact with it.
Remove covering.
Switch.
11