Aileron Control Horn Installation; Elevator Control Horn Installation; Elevator Pushrod Installation - Seagull Models EDGE 540 Assembly Manual

EDGE 540.

AILERON CONTROL HORN INSTALLATION.

1) Aileron control horn:
Mix a small amount of 30 minute epoxy and
lightly coat the inside of the hole in the aileron
and the 3x50mm control horn screw.
Wing.
2) Thread the screw (insert the washer)
into the hole from the top of surface. Wipe away
any excess epoxy on the wing and screw with
rubbing alcohol and a paper towel. Screw the
M3 nut (insert the washer) in place as shown.
Alllow the epoxy to fully cure.
M3 lock nut.
M3 nut.
Aileron control horn.
14
3x50mm.
Aileron.
Wing bottom.
M3 control horn.
Aluminium washer.
Wing bottom.
Instruction Manual.
Repeat the procedure for orther wing.

ELEVATOR CONTROL HORN INSTALLATION.

Repeat the procedure for the elevator control
horn as same as the way of aileron control horn.
Horizontal fin.
Elevator control horn.
Repeat the procedure for orther
elevator.

ELEVATOR PUSHROD INSTALLATION.

Elevator pushrods assembly follow pictures
below.
Pushrod L= 138mm .
M lock.
3
Metal clevis.
Center the servo using the radio system.
Attach the servo arm to the servo using the
screw provided with the servo.
Elevator.