Table of Contents
Advertisement
4.7
Mounting and
Field
Connections
4.7.1
Physical
Dimensions
5.50 in.
(side view)
© Copyright 2018
United Electronic Industries, Inc.
DNR-X-1G Series RACKtangle and HalfRACK Systems
DNR-12-1G: The DNR-12-1G mounting options include mounting on a flat
horizontal surface such as a tabletop or floor, a flat vertical surface such as a
wall, or in a standard 19-inch rack.
•
For horizontal surface mounting, use the rubber feet supplied with the
standard enclosure or bolt the case directly to the surface.
•
For mounting on a vertical wall surface, attach flanges to both ends of
the enclosure with the flanges aligned flush with the rear of the
enclosure; then fasten the flanges to the surface with screws or bolts.
•
For mounting in a standard 19-inch rack, attach flanges to both ends of
the enclosure with the flanges aligned flush with the front of the
enclosure. Then attach the flanges to the rack with bolts.
NOTE: Note that the flanges are included with the purchase of the DNR-X-1G
racks. If you need more clearance from the rack front panel, refer to the
DNR-EXT-BRACKET-4 which provides 3.625 inches of clearance.
DNR-6-1G:The DNR-6-1G mounting options include the same flat horizontal
(tabletop, floor) and vertical surface (wall) options as the DNR-12-1G.
For flat horizontal surfaces, the DNR-6-1G can use the rubber feet supplied with
the standard enclosure or can be bolted directly to the horizontal surface.
For flat vertical surfaces, the DNR-6-1G can be mounted with the flange mounts;
however, since the DNR-6-1G is not 19" wide, UEI recommends using a shelf for
rack installations.
If you need technical drawings, please contact UEI support.
DNR-12-1G: The DNR-12 enclosure used in a DNR-12-1G system is compatible
with Specification EIA-310-C for 19" Rack Mounting Equipment and is designed
to occupy 3U units of vertical space (where 1U is 1.75"). The physical
dimensions of the DNR-12 enclosure are shown below in Figure 4-13.
Note: For wall mounting, align flanges flush with rear of enclosure.
For rack mounting, align flanges with front of enclosure.
Figure 4-13. Physical Dimensions of DNR-12 Enclosure
October 2018
Installation and Configuration
18.31 in.
17.50 in.
(front view)
Chapter 4
56
www.ueidaq.com
508.921.4600
Hide quick links:
Advertisement
Table of Contents
