Password Command; Display Table Of Installed Boards & Logic Version Command - UEi RACKtangle DNR-12-1G Series User Manual

6.4.5 Password
Command
6.4.6 Display Table
of Installed
Boards &
Logic Version
Command
© Copyright 2018
United Electronic Industries, Inc.
DNR-X-1G Series RACKtangle and HalfRACK Systems
Some commands (such as mr, mw, set, and store) require entering a user
password. Once the password is entered, these commands become enabled
until firmware reset.
There are two levels of password protection available. The first is user level and
the second is super-user level. Super-user level is currently used only for
updating firmware over the Ethernet link.
DQ> pswd user sets up a user level password. First, you'll be asked about
•
your old password and then (if it matches) to enter the new password twice.
DQ> pswd su sets up super-user level password. First, you'll be asked
•
about old super-user password and then (if it matches) to enter the new
super-user password twice.
DNR-12 and DNR-6 systems come with both default passwords set to
"powerdna".
Some DaqBIOS commands require clearing up user or super-user password.
Use DqCmdSetPassword() before calling these functions. The PowerDNA API
Reference Manual notes which functions are password-protected.
The devtbl command is another of the more frequently used commands.
This command displays all I/O boards found and initialized by firmware along
with assigned device numbers.
Use these device numbers in host software to address the I/O devices.
DQ> devtbl
Address Irq
-------------------------------------------------------
0xA0000000 2
0xA0010000 2
0xA0020000 0
0xA0030000 2
0xA00C0000 2
0xA00D0000 3
0xA00E0000 3
-------------------------------------------------------
The devtbl command with the logic option added displays the CPU logic
version on each installed I/O board:
DQ> devtbl logic
Logic information:
DevN Mod-opt Logic
-----------------------------------------------
0 207-001 02.12.21
1 650-001 02.11.36
2 364-001 02.11.0A
3 217-001 02.11.9F
4 020-001 02.0D.09
5 040-001 02.10.C4
14 3006-001 02.12.3E
-----------------------------------------------
October 2018
Programming CPU Board-specific Functions
Model Option Phy/Virt
207 1 phys
650 1 phys
364 1 phys
217 1 phys
20 1 phys
40 1 phys
5 1 cpu
CLI CLO
512 512
1024 0
0 4096
2048 512
0 0
0 0
0 0
Chapter 6
S/N Pri DevN
0165992 10
0154839 20
0170276 30
0153841 40
0162268 50
0162861 60
0162789 0 14
LogOption
10127E0
43000040
30000A0
90024E0
101800E
1010081
30303720
www.ueidaq.com
508.921.4600
100
0
1
2
3
4
5