Table of Contents
Advertisement
Chapter 4
4.1
Initial
Installation
Guide
© Copyright 2018
United Electronic Industries, Inc.
DNR-X-1G Series RACKtangle and HalfRACK Systems
Installation and Configuration
The following installation and configuration topics are included in this chapter:
•
Initial Installation Guide (Section 4.1)
•
Initial Boot-up (Section 4.2)
•
IP Address Overview & Update Procedures (Section 4.3)
•
Network Configuration (Section 4.4)
•
Troubleshooting (Section 4.5)
•
Updating Firmware (Section 4.6)
•
Mounting and Field Connections (Section 4.7)
•
Wiring I/O Boards (Section 4.8)
•
Repairing (and Upgrading) a DNR System (Section 4.9)
•
Configuring a NIC Port for Diagnostic Mode (Section 4.10)
•
Disabling Writes to Flash/EEPROM (NVRAM) (Section 4.11)
NOTE: Throughout this chapter, several images show just DNR-6 or DNR-12
systems. Unless otherwise noted, each representation applies to both
systems.
This section describes the procedure recommended for performing an initial
hardware and software setup when you first receive a DNR-X-1G system:
•
Verify shipment contents, Section 4.1.1
•
Install software, Section 4.1.2
•
Verify communication over serial port (optionally) / initial boot up,
Section 4.2
•
Configure IP addresses (if needed), Section 4.3
•
Connect your DNR-X-1G system to your host PC or network switch,
Section 4.4 and Section 4.7 (optionally)
October 2018
Chapter 4
Installation and Configuration
www.ueidaq.com
508.921.4600
36
Hide quick links:
Advertisement
Table of Contents
