Set And Store Commands - UEi RACKtangle DNR-12-1G Series User Manual

6.4.3 Set and Store
Commands
© Copyright 2018
United Electronic Industries, Inc.
DNR-X-1G Series RACKtangle and HalfRACK Systems
The set command allows you to change DNR-X-1G system parameters and
store allows you to save them to system memory (flash).
Typing set <Enter> provides a list of parameter names that can be changed.
DQ> set
Enter user password > ********
Valid 'set' options:
name: <Device name>
model: <Model id>
serial: <Serial #>
option: <Option>
fwct: <autorun.runtype.portnum.umports>
mac: <ethernet address port 1>
srv: <Default IP address port 1>
ip: <IOM IP address port 1>
gateway: <gateway IP address port 1>
netmask: <netmask port 1>
mac2: <ethernet address port 2>
srv2: <Default IP address port 2>
ip2: <diagnostic port IP address>
gateway2: <diagnostic port gateway IP>
netmask2: <diagnostic port netmask>
udp: <udp port (dec)>
license: license string
bond prm: license string
NOTE: The set command may require a password. The default password for
DNR-X-1G systems is "powerdna".
The following are examples of setting DNR-X-1G parameters:
• To set a new Primary IP address (NIC1), type:
DQ> set ip 192.168.1.10
• To set a new Secondary Diagnostic Port IP address (NIC2), type:
DQ> set ip2 192.168.100.3
Other parameters can be changed the same way. Refer to Section 6.4.3.1 for
more information about each of the set parameters.
Once parameters are set, you must store them into non-volatile flash memory:
DQ> store
CRC: crc=0xDB097048 flcrc=DB097048
Flash: 1272 bytes of 1272 stored! CRC=0xDB097048
Old=0xC4F8C173
Xflash: 28 bytes CRC=35AA034B
Configuration stored
After parameters are stored, reset the firmware.
October 2018
Programming CPU Board-specific Functions
Chapter 6 96
www.ueidaq.com
508.921.4600