Setting The Delay Time; Setting The Search Frequency Step; Setting Record - Uniden Trunk Tracker IV BCD996T User Manual

◙
Set Data Skip
This setting controls how the scanner behaves when it stops on a channel that has a data signal.
On — the scanner stops briefly on the channel, but then immediately resumes scanning automatically.
Off — the scanner remains on the channel until the transmission stops. The default setting is Off
Notes:
If you are trying to test the Close Call feature with a nearby transmitter (such as a CB) and you do not talk into the transmitter, the
scanner detects this unmodulated carrier as data and skips the frequency when Data Skip is on. Turn the feature off or talk into the
transmitter to modulate the carrier.
This setting is ignored for AM/WFM/FMB channels.

Setting the Delay Time

[MENU]
Srch/CloCall Opt
Set Delay Time
This setting determines how long the scanner waits after a transmission ends before resuming Quick Search or Close Call operation.
1-5 sec The scanner waits the set amount of time after the transmission ends before resuming. The default setting is 2 sec.
Off The scanner resumes immediately when the transmission ends.

Setting the Search Frequency Step

[MENU]
Srch/CloCall Opt
◙
Set Step
This setting lets you select the frequency step used for setting the channels.
Auto The step is based on the band (see the table at the front of the manual) This is also the default setting.
5.0 kHz, 6.25kHz, 7.5 kHz,
8.33kHz, 10.0 kHz, 12.5 kHz,
15.0 kHz, 20.0 kHz, 25.0 kHz,
50.0 kHz, 100.0 kHz

Setting Record

You can set the RECORD OUTPUT jack to provide an audio signal to a sound recording device (tape, PC, flash memory) for live
recording of transmissions.
[MENU]
Srch/CloCall Opt
◙
Set Record
On — enables an output to an audio recorder at the RECORD OUT jack.
Off — disables an audio signal at the output jack.
Adjust P25 Level
You can select the best threshold for the APCO mode.
[MENU]
Srch/CloCall Opt
Adjust P25 Level
◙
◙
◙
The scanner uses the selected step.
◙
◙
◙
57