Uniden Trunk Tracker IV BCD996T User Manual page 21

4. Press [L/O] to temporarily lock or unlock the current the channel. Double-tap L/O to permanently lockout the current channel.
ID Scan/ID Search Mode
While you are scanning a trunked system, the scanner can be in either ID Scan or ID Search mode:
•
ID Scan – the scanner only stops on talk group ID's (TGID) that you have programmed into the system that are unlocked.
•
ID Search – the scanner stops on any unlocked talk group that becomes active.
To toggle between ID Scan and ID Search, press
If the scanner does not scan the system long enough for you to easily do this, press
changed system. Then, press [SCAN/SEARCH] within 2 seconds.
Holding On a System
To temporarily hold on a system, tap the Scroll Control
control to select the system. Normal scanning resumes 2 seconds after your last selection.
To permanently hold on a site or system, press and hold the Scroll Control for 2 seconds.[F] flashes in the display's upper left
corner. The scanner continues to scan only the current system. To hold on a different site or system, rotate the Scroll Control
select the new site or system then press [E
Holding On a Channel
To hold on a channel, press [HOLD/RESUME] while the channel is active. To select a different channel, turn the Scroll Control. If
you scroll past the beginning or end of the current system, the scanner selects channels in the previous or next system. To resume
scanning, press [SCAN/SEARCH].
Quickly Storing an ID During ID Search
To quickly store an active talk group ID during ID search, press [E/
Quick TGID Save?
To save the ID into a channel, press [E/
group called Qck Save Grp in the current system.
Quick-Storing Channels or Talk Group ID's (TGID)
1. Hold on an existing channel in any system.
2. Enter the frequency or talk group ID you want to store (press twice to enter hyphens in talk group ID's).
3. To quick-store the channel or talk group ID, press [E/
Otherwise, press [.No].
If you enter a frequency then press [E/
Sys. These groups are created if they do not exist. Then, the scanner prompts you to save other channel settings.
If you enter a talk group ID then press [E/
system. If the talk group ID's format is not the type used by the current system, the scanner displays an error message and does not
save the talk group ID.
If you pressed [.No] in Step 3, the scanner prompts you to select the system and the group where you want to store the frequency or
talk group ID.
Note: The scanner will warn you if you try to store two channels in the same system that have the same frequency or Talk Group ID
or if you try to store two systems with the same name.
Trunking Activity Indicators
◙
then press [SCAN/SEARCH] while the scanner is scanning the system.
◙
. To hold on a different system, tap the Scroll Control
].
YES
]. Otherwise, press [. No] . If you press [E/
YES
YES
], the scanner stores it in the Qck Save Grp group in a system called Qck Save Cnv
YES
], the scanner stores it into a channel group named Qck Save Grp in the current
YES
◙
and rotate the Scroll Control to select the
]. You see:
YES
], the scanner stores the ID into a channel
YES
].
21
◙
then rotate the
to