Setting The Delay Mode - Uniden BC 245XLT Owner's Manual

2. You hear a beep, and
ATT appears in the
display begins
flashing.
Now all incoming
signal strength is
reduced.
To turn RF Attenuation off, just press ATT again. The ATT
icon goes out.

Setting the Delay Mode

A delay can be set for each programmed channel so that
when scan or search stops on a channel there is a brief
pause before the scanning cycle resumes. Delay must be
set for each programmed channel and it can be set when
your scanner pauses during a scan or when manual mode
is selected.
Delay in Scan or Search Mode
1. Press
search range and
press
2. When your scanner
stops on a channel
that you want to
delay, press
DLY displays and
scanning resumes two
seconds after the
transmission ends.
or set a
.
.
22