Setting The System Hold Time - Uniden Trunk Tracker IV BCD996T User Manual

•
To unlock the system at startup, press and hold the selected startup key while you turn on the scanner.
•
The system Quick Key is also enabled.
•
If you press a different key at startup, the system is locked out.
•
If you do not assign the system a startup key, the system is not affected by any key press during startup.
Setting the System Lockout
[MENU]
Program System
Select a conventional system
Edit Sys Options
◙
Set Lockout
Unlocked – The system is scanned when its quick key is enabled.
Temporary L/O – The system is not scanned, even if its quick key is enabled. Cycling power will remove the lockout.
Lockout – The system is not scanned, even if its quick key is enabled. You must manually unlock the system.

Setting the System Hold Time

[MENU]
Program System
Select a conventional system
Edit Sys Options
◙
Set Hold Time
Set how long the scanner will remain scanning on this system before moving to the next system (up to 255 seconds). Note that the
scanner will scan all unlocked channels at least one time, regardless of the system hold time setting.
Setting ID Scan/ID Search
[MENU]
Program System
◙
Select a system
Edit Sys Options
◙
ID Scan/Search
Sets whether the scanner only stops on talk groups you have programmed in (ID Scan) or whether the scanner stops on any
unlocked channel (ID Search).
Setting Channel Delay Time
[MENU]
Program System
◙
Select a system
Edit Sys Option
Set Delay Time
This setting controls how many seconds the scanner waits after a transmission ends before resuming scanning. Enter a value from
◙
1-5 or Off, then press .
Notes:
•
The default setting is 2 seconds for each system.
•
This setting applies to all channels within the system.
◙
◙
◙
◙
◙
◙
◙
◙
◙
◙
◙
32
C
C
MEL
MELCS