Firmware Upgrade With Usb Removable Storage - IDEAL Networks LanTEK III Manual

7. Supply the Remote handset (RH) with power by using the adapter.
8. Connect the Display (DH) and the Remote (RH) handset with a patch cord by
using the test adapters.
9. Press Autotest. The Display Handset (DH) reports the version difference.
10. Open Calibration menu.
11. Enable firmware upgrade with
12. Confirm update with
13. Wait until upgrade is finished and normal operating status is displayed on
Remote handset (RH).
9.1.2

Firmware Upgrade with USB Removable Storage

1. Save the firmware upgrade on an empty USB removable storage.
2. Supply the Display handset (DH) with power by using the adapter.
3. Insert the USB removable storage into the USB port of the powered off Display
handset (DH).
4. Power the display handset (DH) on, wait approx. 1-2 seconds, then press and
hold the Escape button until an hourglass appears on the TFT display. Release
the escape button when the hour glass appears.
5. Wait until the upgrade is finished and the main menu appears on the Display
handset.
NOTE:
During the upgrade, the connection to the adapter must not be interrupted.
6. Supply the Remote handset (RH) with power by using the adapter.
7. Connect the Display (DH) and the Remote (RH) handset with a patch cord by
using the test adapters.
8. Press Autotest. The Display Handset (DH) reports the version difference.
9. Open Calibration menu.
10. Enable firmware upgrade with
11. Confirm update with
12. Wait until upgrade is finished and normal operating status is displayed on
Remote handset (RH).
LanTEK III
User Manual
.
.
.
.
161809 Iss 2
Page75