Enable Tone Generator With Remote Handset (Rh) - IDEAL Networks LanTEK III Manual

8.1.2

Enable Tone Generator with Remote handset (RH)

1. Connect Remote handset (RH) to cable to be tested.
2. On Remote handset (RH) press TONE. The tone mode is enabled. The first line of
the two-line Remote handset (RH) display shows the message TONE. In the
second line, the type of tone signal as well as the feed location is shown in XY
format.
X symbol
(Tone)
L = Low
H = High
W = Warble
Example: L78 = low tone ("Low"), pair 78
NOTE:
The Tone Mode remains enabled until you press Escape.
3. Select the wire pair into which the tone signal is to be fed by switching between
the options with the TONE key.
4. Select the tone signal for the selected wire pair by switching between the
options with <SHIFT>+TONE.
LanTEK III
User Manual
Y symbol
(feed location)
78 = Pair 78
36 = Pair 36
54 = Pair 54
12 = Pair 12
161809 Iss 2
Page73