Quick Reference - ETC ColorSource Linear Installation Manual

ETC Installation Guide
ColorSource Linear v1.7

Quick reference

DMX control channels for Linear 1 and Linear 2/Linear 4 in
Group mode
DMX
Channel
1
2
3
4
5
6
*Original ColorSource Linear fixture uses blue in channel 4; Deep Blue fixture
uses indigo in channel 4.
**Use DMX values of 0 or 255 for no strobe. Use values of 1–254 to increase
the strobe rate from 1 per second up to 33 per second.
Error codes
There are three error codes that may be shown on the user interface.

•
with the color calibration. The fixture will need to be returned to the
ETC factory; contact your local dealer to set up a repair.

•
fixture has gone into over-temperature protection mode to avoid
damaging the fixture. Once the fixture has self-cooled, the error will
automatically clear.

•
card or the internal cabling is damaged or unplugged. Verify that
internal cables are properly connected. If the error persists, the fixture
will need to be returned to the ETC factory; contact your local dealer
to set up a repair.

•
upgraded fixtures have a software issue. Reload software to clear the
error. If the error persists, contact ETC.
ColorSource Linear v1.7

(5 Channel)
Intensity
Red
Green
Blue
Strobe**
: Screen toggles between
: Screen toggles between
: Screen toggles between
: Screen toggles between
Page 20 of 20

(Direct) (1 Channel)
Intensity Intensity
Red
Green
Blue/Indigo*
Lime
Strobe**
 
and
 
and
 
and

and
 
(RGB)
Red
Green
Blue
to indicate a problem
to indicate that the
to indicate that a control

to indicate that the
ETC