Mode Button; Setting The Dmx Address; Changing The Dmx Control Mode - ETC ColorSource Linear Installation Manual

Hide thumbs Also See for ColorSource Linear:
Table of Contents

Advertisement

ETC Installation Guide
ColorSource Linear v1.7

Mode button

Pressing the Mode button activates the Presets/Sequences menu; the last
active preset or sequence plays automatically. Pressing the Mode button a
second time deactivates the selected preset or sequence. The display will
revert to show the DMX start address.
• If DMX data is present, the current preset or sequence plays in the
background and DMX data continues to take priority.
• If DMX data is lost and a preset is active in the background, the last
selected preset or sequence automatically plays.

Setting the DMX address

1:
2:
You can also use RDM for DMX addressing. See

Changing the DMX control mode

You can set the DMX control mode for the fixture to one of four available
mode options.
1:
2:
3:
4:
The display will automatically return to the DMX address after 10 seconds of
inactivity, and edits to the DMX control mode will not be saved. This cancels
unsaved changes.
ColorSource Linear v1.7
Press any button to wake the display. The display shows the DMX
address.
Use the Up and Down buttons to select the DMX address for the
fixture.
Press any button to wake the display. The display shows the DMX
address.
Press and hold the Mode button for 3 seconds. The display shows the
current DMX control mode.
Press the Up and Down buttons to change the DMX control mode.

: 5-channel mode (intensity, red, green, blue, and strobe). This
is the default mode.

: Direct emitter control (intensity, red, green, blue, indigo,
lime, and strobe).

: 1-channel mode controls the intensity of preset 1 (defaults to
3200K White).

: RGB mode (red, green, and blue).
Press the Mode button to confirm your selection.
Page 8 of 20
Using RDM
page 17
on
.
ETC

Advertisement

Table of Contents
loading

Table of Contents