ETC Installation Guide
ColorSource Linear v1.7
Restoring factory defaults
Press and hold the Mode, Up, and Down buttons simultaneously for
5 seconds. The DMX start address will blink once to confirm that defaults
have been restored.
Error codes
There are three error codes that may be shown on the user interface.
•
with the color calibration. The fixture will need to be returned to the
ETC factory; contact your local dealer to set up a repair.
•
fixture has gone into over-temperature protection mode to avoid
damaging the fixture. Once the fixture has self-cooled, the error will
automatically clear.
•
card or the internal cabling is damaged or unplugged. Verify that
internal cables are properly connected. If the error persists, the fixture
will need to be returned to the ETC factory; contact your local dealer
to set up a repair.
•
upgraded fixtures have a software issue. Reload software to clear the
error. If the error persists, contact ETC.
ColorSource Linear v1.7
: Screen toggles between
: Screen toggles between
: Screen toggles between
: Screen toggles between
Page 16 of 20
and
to indicate a problem
and
to indicate that the
and
to indicate that a control
and
to indicate that the
ETC