Table of Contents
Advertisement
ETC Installation Guide
ColorSource Linear Pearl v1.7
Quick reference
DMX control channels for Linear 1 and Linear 2/Linear 4 in
Group mode
DMX
Channel
1
2
3
4
*Use DMX values of 0 or 255 for no strobe. Use values of 1–254 to increase
the strobe rate from 1 per second up to 33 per second.
Error codes
There are three error codes that may be shown on the user interface.
•
with the color calibration. The fixture will need to be returned to the
ETC factory; contact your local dealer to set up a repair.
•
fixture has gone into over-temperature protection mode to avoid
damaging the fixture. Once the fixture has self-cooled, the error will
automatically clear.
•
card or the internal cabling is damaged or unplugged. Verify that
internal cables are properly connected. If the error persists, the fixture
will need to be returned to the ETC factory; contact your local dealer
to set up a repair.
•
upgraded fixtures have a software issue. Reload software to clear the
error. If the error persists, contact ETC.
ColorSource Linear Pearl v1.7
(Variable
Color Temperature)
Intensity
Color temperature
: Screen toggles between
: Screen toggles between
: Screen toggles between
: Screen toggles between
Page 20 of 20
(Direct)
Intensity
Warm white
Cool white
Strobe*
and
to indicate a problem
and
to indicate that the
and
to indicate that a control
and
(1 Channel)
Intensity
to indicate that the
ETC
Advertisement
Table of Contents
