Flashforge Creator Pro User Manual page 53

●Cold Pause
After selecting it and pressing OK, the extruder and build plate will move to the
initial position. It may cost several seconds. And then the display will indicate:
●Back to Monitor
●Cancel Print
●Unpause
After selecting it and pressing OK, the extruder begins heating up. The printer
will resume printing when the extruder reaches the target temperature.
●Jog Mode
●Filament Loading
●Change Speed
●Change Temperature
●Change HBP Temp
●Set lights OFF
●Print Statistics
Creator Pro User Guide | www.FlashForge.com
53
400-699-1063