Flashforge Creator Pro User Manual page 50

Display Config
select it and then press
Change Name
Save To Profile
●Home offsets
select it and then press
●Toolhead Offsets
●Jog Mode
select it and then press
X+
Y-
X-
Press Right/Left button change the X/Y/Z axis interface; press
Up/Dn button to change the coordinate; press OK button to back.
●Enable steppers
select it and then press
Creator Pro User Guide | www.FlashForge.com
OK
Config
X Offset
Y Offset
Z Offset
Right Temp
Left Temp
Platform Temp
OK ; the display will indicate:
X Offset
Up/Dn/Left/OK to Set (Press Up button and Down button to
change the X/Y axis coordinate; press OK to confirm; press Left
button to back)
OK ; the display will indicate:
OK ; the display will indicate:
; the display will indicate
50
400-699-1063