Loading The Filament Using The Lcd Panel - Flashforge Creator Pro User Manual

7.2 Loading the Filament Using the LCD Panel

1. Turn on the Creator Pro; the display will indicate:
▶ Print from SD
Preheat
Utilities
2. Using the directional arrow buttons in the right of the screen, to select
then press the OK. The display will show:
Monitor Mode
▶ Filament loading
Preheat Setting
General Settings
3. Select Filament loading;
▶ Load Right
Unload Right
Load Left
Unload Left
4. Select the appropriate side of the extruder you wish to load (Left or Right for
models with dual extruders). Press the
indicate: I'm heating up my extruder!" At this time, the temperature of the right nozzle
is being heated up. When the temperature of the nozzle reaches its target temperature,
Creator Pro User Guide | www.FlashForge.com
7-9
press the OK key of the keypad. The display will show:
OK
key again on the keypad. The display will
45
Utilities
and
400-699-1063