Flashforge Creator Pro User Manual page 36

● Speed
a. Print Speed is the moving speed of the extruder. Generally, the lower speed is,
the better print you will get. For PLA printing, 80 is recommended.
b. Travel Speed is to control the moving speed of the extruder under non-
printing Status during work. For PLA printing, 100 is recommended.
Note: Modify parameters settings to get better prints as different models need
different parameters.
● Temperature
Extruder Temperature: Recommended extruder temperature is 220℃.
Note: Different temperatures have subtle influences in prints. Please adjust the
temperature according to the condition in order to get a good print.
Platform Temperature: To set the temperature of Platform.
● Others
Cooling Fan Control: Set up the time to turn on the cooling fan. You can pre-set
the height and make the cooling fan begin to work at the point.
6.2.12 File Menus
①New Project
Click [File]--[New Project]
modification on previous project, then it will inform you whether the modification
needs to be saved or not. Click
will abandon it. If click
Creator Pro User Guide | www.FlashForge.com
can build a blank project. If there is an unsaved
[Yes] will save the modification, and then click
[Cancel] or close tool tip, then it will cancel the new project.
6-16
36
[No]
400-699-1063