Table of Contents
Advertisement
Error message on display panel
Load Error
Purge failed
Unload Error
Unload failed
Model/Support Jam
in head clear before resuming
Pausing
Note: Certain Filament related error messages will allow you to enter
maintenance mode after a 20 second time out.
Fault determination codes
If a fault occurs which would prevent the printer from executing an operator request, the
printer will begin to shut down and cool. The panel will display an error code. An error-code
list (with the filename "error.txt") can be found on the CD-ROM for the printer system
software. (Because this list may change with each new software version, be sure to check the
error.txt attachment when you install new system software upgrades.)
After the printer has finished cooling, the only option displayed is
and the printer will reboot and try to return to normal operation. If pressing
not eliminate the error, power should be cycled (see
seconds before switching power on again. In most cases you will be able to continue
operation. However, if the printer continues to shut down and display the same error,
contact technical support.
uPrint/uPrint SE Service Manual
Recommendation
1.
Remove the carrier and verify material is coming out of the material
guide.
2.
Verify the material pulls freely from the carrier.
3.
Verify the material tubes are free of material.
4.
Check for and clear any excess material build up around the tips.
Remove the carrier and verify the material tubes are free of material.
"Material Jam" on page 6-6.
1.
Press
.
Resume
2.
Unload the material carriers and reinstall.
Continue
Cycling power on page 6-4.
. Press
Continue
does
Continue
); wait 60
.
6-3
Advertisement
Table of Contents
Troubleshooting
