System Fault Light; System Status Light; Shut Down Status Light - Stratasys Finishing Touch User Manual

System Fault Light

The system fault light will illuminate indicating there is a fault in the
system. Refer to the

System Status Light

When the system is ready to begin smoothing parts, the green system
status light will be illuminated. When the stop button is pressed, the light
will turn off.

Shut Down Status Light

Once the stop button is pressed (or four hours have elapsed without the
lid over the smoothing chamber being opened), the red shut down light
will begin flashing. The flashing indicates that the system is shutting
down. When the shutdown cycle is complete, the light will remain steady
on indicating that the system shutdown is complete.
1-10
"Troubleshooting Chart" on page 4-4 for details.
Introduction