Stratasys uPrint Service Manual page 127

Figure 4-136: Removing the toggle sensor cable from the head board
Feed toggle sensor
cable through the
head board
14.
Disconnect the substrate sensor cable and filament motor cables from the rear of the head
board by pressing the tabs in and pulling outward. See
Disconnect the
3 cables
1
15.
Using a ⁄ " nut driver or standard screwdriver, remove the 4 head board mounting
4
screws. See Figure 4-138.
Figure 4-138: Remove the head board mounting screws
Remove the head
board mounting screws
4-80
Figure 4-137: Rear head board cable locations
Figure 4-137.