Smtp Setup; E-Mail Setup - Optiview VR Enterprise User Manual

SMTP setup

2.5.1
【SMPT Server】SMTP server address, eg: mail.jstDVR.com
【SMPT Port】Port that SMTP will listen for a connect request on.
【Auth. Type】Logon mailbox, operator will select ―Simple Login‖ or
―None‖
【Login User ID】Mailbox's ID.
【Login Pass】 Mailbox's password.
After you have finished setup you can press
function.

E-Mail setup

2.5.2
【Send To】Set address of receiver.
【Copy To】Option to an additional recipient.
【User Email】Enter email address of sender.
【Email Title】Enter subject of the E-Mail to be sent.
【Grab Picture As Attachment】 If enabled a snapshot will be sent as
an attachment with the alarm notification email. When disabled no attachment
will be sent.
【Alarm Send Email Cameras(Screenshot From Alarm Camera)】 You
can select the cameras that will trigger an e-mail when there is an alarm. The
cameras you select are only the cameras of the local board card, IP Cameras
are not included.
【Alarm Send Email Sensors(Screenshot From Linked Camera)】
You can select the sensor that will trigger an e-mail when there is an alarm.
*NOTE: If "Send the grab picture as the attachment", you should check the alarm of the camera
or the sensor, and set "alarm send to network" to be enabled.
DVR Server Manual ver.6.05/rel.120909
46
to test the