Section 4: Registration; Registering The Communicator; Register Through The Alarmnet Direct Website - Honeywell IntelliPath Series Installation And Setup Manual

.
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •

Registering the Communicator

Once you have initialized and programmed the communicator, it must be registered to
enable the account. The registration status is indicated below:
LED DESCRIPTION
STATUS ON – Is NOT registered with AlarmNet.
(green) OFF – Is registered with AlarmNet.
MESSAGE ON – Message transmission pending.
(yellow) QUICK PERIODIC BLINK - Normal
SLOW BLINK – In unison with green LED,
FAULT OFF – No fault present.
(red)
Upon completion of the registration process, the communicator transmits a registration
message and receives a registration validation indicating that the account is now enabled.
Wait for the "Registration Success" message to appear, regardless of which registration
method used.
You can register the communicator by one of the following methods:
• Through the AlarmNet Direct website
• Through use of the Tamper Switch
• Through use of a 7720P Programming Tool
• By phone

Register through the AlarmNet Direct Website

The communicator can be registered through the AlarmNet Direct Website. To program the
communicator via the website (if you are already signed up for this service), go to:
https://services.alarmnet.com/AlarmNetDirect/
Log in and follow the on-screen prompts.
If you are not signed up for this service, click on "Dealer Signup" from the login screen to
gain access to the Honeywell web-based programming.
Dealer Sign-Up Direct Link:
You will be instructed how to proceed upon completing the sign-up form. Only one sign-up
per dealer is required. Once an initial user is established, additional logins may be created
by that user.
NOTE: Central Stations sign up by contacting AlarmNet Administration at 800-222-6525
option 3.
Please have the following information available when programming the device:
Registration in progress.
STATUS
MESSAGE
https://services.alarmnet.com/AlarmnetDirectP_SignUp/
S E C T I O N
Registration
FAULT
4
4-1