Using The Control Panel Programming Mode; Programming Conventions; Ecp Mode Programming - Honeywell IntelliPath Series Installation And Setup Manual

KEY
5 / E
6 / F
7 / S
8 / T
9 / X
SPACE
0
# / ENTER
* Active only when the "Exit Programming Mode" prompt is displayed.

Using the Control Panel Programming Mode

Most control panels support programming of the communicator through the control
panel programming mode (refer to the control panel's installation guide). If program-
ming through the control panel, only the ECP Mode programming options are available.
The "mode" prompts will not be displayed, and the mode cannot be changed. For a
description of key functions on the control panel keypad, and how they map to the
7720P Programming tool, refer to the control panel's Programming Guide.

Programming Conventions

Programming is accomplished by answering a series of prompts. Most prompts require only
a [Y]es or [N]o response, while others require a numerical response (ID numbers, etc.).
The current value is displayed on the second line in parentheses ( ). A "?" indicates an
invalid entry.
Use the [ENTER] key to accept the current entry and proceed to the next prompt. If the
entered value is invalid, pressing [ENTER] re-displays the prompt; the next prompt is not
displayed until a valid answer is entered.
Use the up / down arrow keys to scroll through the programming prompts without changing
any values. Press the [ESC] key to go to the end of the list of prompts.

ECP Mode Programming

The communicator supports ECP messaging via the control panel's ECP bus. These
messages are in Contact ID format. (Not all control panels support the ECP bus, so be sure
to check the control panel's Installation and Setup Guide to see if it supports this feature.)
Press the [ENTER] key to begin programming.
NOTE: The central station can remotely block access to local device
Table 3-2: Programming the communicator for ECP mode only.
PROMPTS
Strt Prog Mode?
1
(Y/N)_
Enter Password:
2
NORMAL KEY FUNCTION
[5]: For entering the number 5
[6]: For entering the number 6
[7]: For entering the number 7
[8]: For entering the number 8
[9]: For entering the number 9
[SPACE]: For scrolling option list
[0]: For entering the number 0
[#/ENTER]: Starts programming mode;
Press to accept entries
programming. If this has been done, the following prompt appears:
OPTIONS
[Y], [N]
Enters programming mode.
[0-9, A-F, N, S, If a password has been previously assigned, this prompt appears.
T, X, Y] Enter a 4-digit password (0-9, A-F, N, S, T, X, Y).
The next prompt appears.
Section 3: Programming the Communicator
SHIFT KEY FUNCTION
[E]: For entering letter E
[F]: For entering letter F
[S]: For entering letter S
[T]: For entering letter T
[X]: For entering letter X
No SHIFT function
No SHIFT function
No SHIFT function
DESCRIPTION
Access to Prog
Mode Denied
3-3