Honeywell IntelliPath Series Installation And Setup Manual page 36

IGSMHS4G Installation and Setup Guide
PROMPTS
Invert Zn7 Y/N
62
(N)_
Restore Zn7 Y/N
63
(Y)_
Delay Zn7 (secs)
64
(00)_
Rpt Zn7 ONLY if
65
Armed (N)_
NOTE: The next two prompts (2 x 4204 Emulation Device Mode) are available ONLY when option "Tamper Rpt" is
DISABLED.
Restore Zn8 Y/N
66
(Y)_
Delay Zn8 (secs)
67
(00)_
NOTE: Prompts 68 through 73 only appear if the Comm Path Choice is IP, or IP&GSM.
Use DHCP Y/N
68
(Y)_
NIC IP Address:
69
255.255.255.255_
Subnet Mask:
70
255.255.255.255_
Gateway IP Addr:
71
255.255.255.255_
DNS Serv IP
72
Addr:
255.255.255.255_
3-18
4204/
ZONE
OPTIONS
TRIG.
2-4204
[Y], [N]
4 4204
only
[Y], [N]
4 4
[01-15]
4 4
[00] = no
delay
[Y], [N]
4
2- [Y], [N]
4204
only
[01-15]
2-
4204
[00] = no
only
delay
[Y], [N]
4 4
12 digit:
4 4
xxx.xxx.xxx.x
xx
12 digit:
4 4
xxx.xxx.xxx.x
xx
12 digit:
4 4
xxx.xxx.xxx.x
xx
12 digit:
4 4
xxx.xxx.xxx.x
xx
DESCRIPTION
Inverts the alarm and normal states of the zone 7
trigger; otherwise uses normal input signal.
Enables restore reporting for zone 7.
Zone Trigger mode: This prompt will only be
displayed if zone 7 is not used as the conditional
(arming) trigger zone.
UL: Must be set to "Y."
Defines the reporting delay in seconds for
zone 7.
Zone Trigger mode: This prompt will only be
displayed if zone 7 is not used as the conditional
(arming) trigger zone.
UL: Must be set to 00.
Reports alarms on zone 7 ONLY if the conditional zone
(zone 4 in 4204 mode; zone 8 in 2-4204 mode) is
triggered (armed).
If [N], always reports alarms on zone 7.
2-4204 mode: If any zone is programmed to "Report
Only if Armed," or if tamper is enabled, skip to Prompt
68: "Use DHCP."
Enables restore reporting for zone 8.
UL: Must be set to "Y."
Defines the reporting delay in seconds for
zone 8.
UL: Must be set to 00.
Dynamically allocates the IP addresses (recommended);
then skip to Prompt 73: "Enable Pwr Save". If [N], uses
fixed IP addresses.
Enter the 4-part address for this device. The 4 parts of
the address must be separated by spaces (displayed as
periods in Review mode).
Enter the 32-bit address mask used to indicate the
portion (bits) of the IP address that is being used for the
subnet address. The 4 parts of the address must be
separated by spaces (displayed as periods in Review
mode).
Enter the 4-part address assigned to the Gateway. The
4 parts of the address must be separated by spaces
(displayed as periods in Review mode).
Enter the 4-part IP address assigned to the DNS
(Domain Name System) server. The 4 parts of the
address must be separated by spaces (displayed as
periods in Review mode).