System Status Displays - Honeywell IntelliPath Series Installation And Setup Manual

IGSMHS4G Installation and Setup Guide
CNtry NetW LAC
xxx xxx
Cell BaseST Chan
xxxx xxxx
Second Site
Available
[F] NOTE: The Network Diagnostic Test is available only if the Comm Path Choice is "IP&GSM" or "IP".
Testing Gateway
Redir 1

System Status Displays

[S]
ECP 67 TmPB
xx 5 ++
1234 67 TmPB Flt
5555 xx 5 ++ OK
12345678 TmPB Flt
5555555x 5 ++ OK
1234567 TmPB Flt
5555555 5 ++ OK
5-4
Status Display Screen 3
CNtry – Country Code
xxxxx
NetW – Network Code
LAC – Local area code
Press the [space] key to get to the next screen.
Press the [backspace] key to go to the previous field.
Status Display Screen 4
Cell – Base Station ID
xxx
BaseST – Base Station Antenna Sector
Chan – Control Channel in use
Press the [space] key to go to the next screen.
Press the [backspace] key to go to the previous field.
Status Display Screen 5
RSSI
Secondary Site RSSI availability. Available or Not Available will be
displayed.
Press the [space] key to go to Status Display Screen 1.
Press the [backspace] key to go to the previous field.
Run Network Diagnostic Test
Performs a set of network diagnostics that tests the integrity of the links
between the communicator and the various connection points (Redirs) to
AlarmNet. Refer to Section 6: Network Diagnostics.
ECP Mode
Flt
Displays the zone and system fault status.
OK
Press the [Space] key to go to the next field.
Press the backspace [BS] key to go to the Line Voltage display.
4204 Emulation Mode
Displays the zone and system fault status.
Press the [Space] key to go to the next field.
Press the backspace [BS] key to go to the Line Voltage display.
Two-4204 Emulation Mode
Displays the zone and system fault status.
Press the [Space] key to go to the next field.
Press the backspace [BS] key to go to the Line Voltage display.
Zone Trigger Mode
The status display includes:
Zone input status (1234567) – the numbers 1-7 represent the 7
mappings of the zone input, and follow Honeywell's ADEMCO high-speed
format codes:
1 = New Event
5 = Normal
X = Not Enabled
Tm – Tamper status follows high-speed format codes above.
P – Represents line voltage as follows:
+ = Power line voltage OK
– = Power line voltage bad and reported