Section 4: Registration; Registering The 7845Gsm; Registering Through Alarmnet Direct Website - Honeywell AlarmNet 7845GSM Installation And Setup Manual

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
In This Section
o

Registering the 7845GSM

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
Registering the 7845GSM
Once you have initialized and programmed the 7845GSM, it must be registered to enable the
account.
Message slow blinking, and Fault not lit.
Figure 11. Unregistered 7845GSM Status Display In Normal Operation
Throughout this document, the following key is used to describe LED state:
Upon completion of the registration process, a 7845GSM transmits a registration message
and receives a registration validation indicating that the account is now enabled. Wait for
the "Registration Success" message to appear, regardless of the registration method used.
You can register the 7845GSM by one of the following methods:
•
•
•
•

Registering through AlarmNet Direct Website

The 7845GSM can be registered through the Alarmnet Direct Website. To program the
module via the website (if you are already signed up for this service), go to:
https://services.alarmnet.com/AlarmNetDirect/userlogin.aspx.
Log in and follow the on-screen prompts.
If you are not signed up for this service, click on "Dealer Signup" from the login screen to
gain access to the Honeywell web-based programming.
Dealer Sign-Up Direct Link: https://services.alarmnet.com/AlarmNetDirectP_Sign-Up.
WWW.DIYALARMFORUM.COM
An unregistered 7845GSM is indicated on the Status Display as: Status lit,
STATUS, GREEN
MESSAGE, YELLOW
FAULT, RED
ON
Figure 12. LED Key
Through the AlarmNet Direct website
Through use of the Tamper Switch
Through use of a 7720P Programming Tool
By phone
WWW.DIYALARMFORUM.COM
o
OFF FAST BLINK SLOW BLINK
S E C T I O N
Registration
4
4-1