Table of Contents
Advertisement
Registering the 7847i-E
Once you have initialized and programmed the 7847i-E, it must be registered to enable the
account. An unregistered unit is indicated on the Status Display LEDs as: Status lit,
Message slow blinking, and Fault not lit. The Internet Link may be lit or blinking. Refer to
Appendix A for a detailed discussion of LED operation.
Figure 9. Unregistered 7847i-E Status Display In Normal Operation
Throughout this document, the following key is used to describe LED state:
To complete the registration process, a 7847i-E transmits a registration message and
receives a registration validation indicating that the account is now enabled.
You can register the 7847i-E by one of the following methods:
•
•
Using the Tamper Switch
Initiate the registration sequence by clicking the Tamper Switch three times.
You can monitor the registration process by viewing the Status Display. The Message
(yellow) LED and the Status (green) LED will blink slowly in unison while the registration is
in progress.
Once the registration has been completed successfully, the 7847i-E enters normal operating
mode; the Status (green) LED goes out and the Message (yellow) LED is lit to indicate that
the power-on / reset message is waiting to be sent. This message will appear at the receiving
station as "E339 8xx", where "xx" is the ECP device address. The description may read
"Trouble – Exp. Mod. Reset". If registration is not validated within 90 seconds, the unit
times out, and the (green) LED will be lit (solid).
If repeated registration attempts time out, check your Internet connection and verify that
7847i-E account information has been entered correctly.
The power-on/reset message will be sent in ADEMCO High-Speed format if the module is
programmed for zone trigger, 4204 or 2x4204 modes.
Using the Programming Tool
The interactive registration feature allows the installer to register the 7847i-E through a
series of keyboard commands on the 7720P Programming Tool. This method of registration
lets the installer monitor the registration process.
Registering ...
Figure 10. LED Key
Through use of the Tamper Switch
Through use of a 7720P Programming Tool
Once the installation is complete, press the [↑] key on the 7720P.
The registration message is sent and the unit waits for the
acknowledgment.
S E C T I O N
Registration
4
4-1
Hide quick links:
Advertisement
Table of Contents
