Waters 2690 Quick Start Manual page 33

Table 3-1 Status Screen Parameters (Continued)
Parameter
Syr
Vial
Ndl Wash
Sample
Column Temp
Injector
486 (1) and (2)
λ
•
• Lamp
• AUFS
2487 (1) and (2)
λ
•
• Lamp
• AUFS
Indicates the current position of the syringe. Valid positions are:
• Home – Default position
• Empty – Highest position (to purge the syringe)
• Full – Lowest position (to draw in sample)
Indicates the number of the vial that is currently under the
injector.
Indicates whether the needle-wash pump is on.
Indicates the current pressure in the sample loop.
Indicates the desired and current temperature of the column (if
the column heater is installed).
Indicates the current position of the injector. Valid positions are:
• Stream – In the high pressure stream
• Seal – In the lower seal position
• Wet – In the needle wash position
• Vial – In the sample vial
Indicates the current status of the following parameters for the
486 detector(s) (if installed).
• Wavelength
• Lamp On or Off
• Absorbance Units Full-Scale
Indicates the current status of the following parameters for the
2487 detector(s) (if installed):
• Wavelength
• Lamp On or Off
• Absorbance Units Full-Scale
Description
Performing a Direct Control Run 33