Performing A Direct Control Run; Setting Up A Direct Control Run - Waters 2690 Quick Start Manual

3
Performing a Direct Control
Run
This section describes the procedures for performing a direct control (manual) run.
Figure 3-1 provides an overview of the procedures. To make an automatic run, refer to
Section 4, Making Automatic
You perform direct control runs from the Status screen
fields in the Status screen indicate the status or values of the current operating
parameters, as described in
values for certain parameters.
30

Performing a Direct Control Run

Runs.
Menu
Press /
Status
Key
Select Separation
Method, or Enter
Parameter Values in
the Status Screen
Direct
Press the
Function
Screen Key
Figure 3-1 Setting Up a Direct Control Run
Table 3-1. The Status screen also allows you to enter new
Select the Direct
Function to Perform
Enter the Function
Parameters
The Function
Begins to Run
(Figure 3-2 and Figure 3-3). The