3. Enter the number of samples to run, then press the
4. Enter the location of the first sample vial, then press the
You must use consecutive sample vials on one or more carousels.
5. Repeat steps 3 and 4 if the sample template includes multiple separation
methods.
6. Enter the number of standards in the run, then press the
7. Enter the location of the first standard vial, then press the
You must use consecutive standard vials.
8. Make sure that the solvents listed in the dialog box are primed and in the
appropriate inlet tubes, then press the
Modifying a Sample Set During a Run
You can modify operating conditions during a run in a stand-alone mode by:
• Using the stat run function
• Editing the separation method
Performing a Stat Run
You can use the stat run function to interrupt a run in progress and perform one or more
injections after the current injection is done, then continue with the scheduled run.
Performing a stat run is most useful when running separation methods that use identical
solvents and temperatures.
Figure 4-5 Setup Dialog Box
Start
Continue
screen key.
Continue
Continue
Continue
screen key.
Making Automatic Runs
screen key.
screen key.
screen key.
41