Fluke Calibration 5730A Operator's Manual page 114

5730A
Operators Manual
There are selections without a submenu listed beneath them that are used to start
processes. For example, the Run DC Zero selection from the Calibration menu starts the
DC Zero process (see Chapter 7).
There are several types of selections that are used for settings. In general, these selections
show what is being set in white, and the value that it is currently set to is in amber. See
the Temperature °C selection in the screen above.
Touchscreen selections with two possible values look like the Confidence Level
selection shown in the screen below. Touch Confidence Level to change the value from
99% to 95%. Touch it again to change the value back to 99%.
4-50
Setup Menu Calibration
Run DC Zero 3/04/2013
Run Artifact Cal 3/04/2013
Run Calibration Check
Run Wb Gain Cal 8/29/2013
Run Wb Flatness Cal 8/29/2013
Change Calibration Passcode
Restore Factory Defaults
Instrument
Setup Menu
Setup
Calibration Interval 1 Year
Range Adjustment
DC
AC
Resistance
Generate Report
Calibration Shifts
Check Shifts
Raw Data
Temperature ˚C
Uncertainty
Information
Confidence Level
23.0
Exit
hhp173.eps
99%
Exit
hhp107.eps