Fluke Calibration 5730A Operator's Manual page 164

5730A
Operators Manual
EMULATE
Description
Parameter
Example
EMULATE?
Description
Parameter
Response
ENETPORT
Description
Parameter
Example
ENETPORT?
Description
Parameter
Response
Example
EOL
Description
Parameter
Example
6-30
Table 6-5. Commands (cont.)
Partially emulates a 5700A or 5720A over the remote interface. This changes the model
number in the *IDN? response. It also accepts BTYPE VB5205 and implements it as if
BTYPE VBNONE was sent, as a Fluke 5205A cannot be connected to the 5730A
Calibrator.
(Integer) 5700 selects 5700A emulation; 5720 selects 5720A emulation; anything else
selects normal 5730A behavior.
EMULATE 5720
Sets 5720A emulation.
Returns the state of emulation as set by the EMULATE command.
None
(Integer) 5700 for 5700A emulation, 5720 for 5720A emulation, 0 for normal behavior.
Sequential command. Ignored if not in remote. Sets the Ethernet port number.
Port number
ENETPORT 3490
Sets the Ethernet port number to 3490.
Sequential command. Returns the Ethernet port number.
None
Integer
ENETPORT?
Returns 3490 if the Ethernet port number is set to 3490
Sequential command. Ignored if not in remote. Sets the end of line terminator for
outgoing data for a specified remote port.
1. SERIAL, USB, ENET
2. CRLF, CR, LF
EOL ENET, CR
Sets the end of line terminator for Ethernet communication to CR.