Password Entry; Password Change - AUMA SA 07.2 Operation Instructions Manual

SA 07.2 SA 16.2/SAR 07.2
AC 01.2 Intrusive
Password
6.4.1

Password entry

6.4.2

Password change

Select main menu
SAR 16.2 Control unit: electromechanic
Figure 32: User level display (example)
A password must be entered to allow parameter modification. The display indicates:
Password 0***
A specific password is assigned to each user level and permits different actions.
Table 7: User levels and authorisations
Designation (user level)
Observer (1)
Operator (2)
Maintenance (3)
Specialist (4)
Service (5)
AUMA (6)
Display indicates: Password 0***
1. Select desired menu and hold down push button
Display indicates the set user level, e.g Observer (1)
2. Press Up ▲to select a higher user level and press
Display shows: Password 0***
3. Use push buttons
4. Confirm first digit of password via push button
5. Repeat steps 1 and 2 for all further digits.
Having confirmed the last digit with
user level is possible if the password entry is correct.
Only the passwords of same or lower user level may be changed.
Example: The user is signed in as Specialist (4). This authorises him or her to modify
the passwords between user levels (1) to (4).
Device configuration M0053
Service functions M0222
Change passwords M0229
Menu point Service functions M0222 is only visible if user level has been set to
Specialist (4) or higher.
1. Set selector switch to position 0 (OFF).
2. Press push button C Setup and hold it down for approx. 3 seconds.
Display goes to main menu and indicates: ▶ Display...
Authorisation/password
Verify settings
No password required
Change settings
Default factory password: 0000
Reserved for future extensions
Change device configuration
e.g. type of seating, assignment of output
contacts
Default factory password: 0000
Service staff
Change configuration settings
AUMA administrator
Up ▲ Down ▼ to select figures 0 to 9.
Ok, access to all parameters within one
Operation
for approx. 3 seconds.
Ok to confirm.
Ok.
29