Mounting Positions: Modify - AUMA SA 07.2 Operation Instructions Manual

SA 07.2 SA 16.2/SAR 07.2
AC 01.2 Intrusive
4.5.1

Mounting positions: modify

SAR 16.2 Control unit: electromechanic
Figure 11: Mounting positions C and D
Hazardous voltage!
Risk of electric shock.
Disconnect device from the mains before opening.
Electrostatic discharge ESD!
Risk of damage to electronic components.
Earth both operators and devices.
1. Loosen screws and remove the local controls.
2. Check whether O-ring is in good condition, correctly insert O-ring.
3. Turn local controls into new position and re-place.
Cable damage due to twisting or pinching!
Risk of functional failures.
Turn local controls by a maximum of 180°.
Carefully assemble local controls to avoid pinching the cables.
4. Fasten screws evenly crosswise.
Assembly
17