Connecting The Power Cable - Eizo CuratOR LX491W Instructions For Use Manual

Connecting

5.5 Connecting the power cable

5.5 Connecting the power cable
DANGER
Connecting to line power
• The device is designed for line power with a grounded neutral conductor.
• To avoid risk of electric shock, this device must only be connected to line power with a
protective conductor.
• Contact the responsible building technician or a qualified electrician if you are uncertain
whether the line power is equipped with a protective conductor.
CAUTION
• Only use power cables or device connection cables with protective conductors and ap-
pliance plugs according to DIN 49 547, IEC 60320 (max. length 3 m). Furthermore, the
cable must adhere to all local safety regulations applicable to the specific country in
which the monitor is used.
• Device fuses should only be replaced in repair centers or by service personnel.
• Note for North America: Molded power plugs must comply with the requirements for
hospitals with respect to CSA Std. C22.2 No. 21 and UL 498.
CAUTION
Opening the connector panel cover
Only service may open the connector panel cover. Patients must not be present when the
cover is open.
CAUTION
Connector
Connectors may only be plugged in or removed by Service when the device is switched
off.
The monitor is supplied power via an appliance plug in the connection panel on the back of
the monitor.
Prerequisite
• The monitor is installed in the ceiling suspension or wall mount unit, or on a stand.
• The screws for attaching the cover to the connection panel are accessible.
See also Connector locations [} 18]
Procedure
1. Using a suitable tool, remove the connection panel cover.
2. Connect the appliance plug to the monitor power socket.
3. The power cable can be secured using a cable grip.
4. Place the cover back on the connection panel.
22
and Installing the monitor [} 16].
CuratOR LX491W
Instructions for Use, 02/2018