Product-Specific Safety Information - Eizo CuratOR LX491W Instructions For Use Manual

Safety information

2.2 Product-specific safety information

2.2 Product-specific safety information
CAUTION
Careful installation of the stand
The tilt, position, and height of the monitor can be changed when the monitor is installed
on a stand. Note the following to prevent injuries or damage when installing or adjusting
the stand:
• Make sure that you do not pinch or injure your fingers or any other parts of the body.
• Make sure the monitor does not collide with the table or other objects, which could re-
sult in damage.
CAUTION
Ensure monitor stability
Stability must be ensured after installing the monitor on a stand. An unstable stand can
cause the monitor to tip over and cause injuries or damage. Therefore make sure the
stand is stable.
• Only use a stand that has been tested for the monitor's weight and that is approved for
tilting up to 10°.
• The screw insertion depth into the monitor must be within the acceptable range.
NOTICE
Radio interference
This is a Class B device.
The device may cause radio interference or interfere with the operation of other devices in
close proximity. In this case the user is encouraged to perform appropriate measures to
correct the interference.
NOTICE
Medical System
• Do not connect devices that are not part of the medical system.
• If a stand is subsequently attached to the monitor, the stand must meet the require-
ments of standard EN 60601 so that the system, comprising the stand and monitor,
meets the requirements.
Note
No zero error rate
LCD monitors do not have a zero error rate For this reason, the image parameters can
change over time, e.g. reduced luminance or changing/fading colors.
Note
Image quality
To maintain constant image quality, EIZO recommends cleaning the monitor on a regular
basis and checking image properties in accordance with all applicable local regulations.
10
CuratOR LX491W
Instructions for Use, 02/2018