Connecting The Power Cable - Eizo CuratOR LX1910 Instructions For Use Manual

Procedure
1. Connect the signal cable to the DVI-I connector or the DisplayPort connector of the moni-
tor.
Note: All signal inputs can be connected at the same time.
2. Tighten the screws to secure the DVI-I signal cable.
3. If necessary, connect the USB cables to the upstream or downstream USB port of the
monitor.

5.4 Connecting the power cable

DANGER
Connecting to line power
• The device is designed for line power with a protective earth conductor.
• To avoid risk of electric shock, this device must only be connected to line power with a
protective earth conductor.
• Contact the responsible building technician or a qualified electrician if you are uncertain
whether the line power is equipped with a protective earth conductor.
CAUTION
• Only use power cables or cable connection cables with protective conductor and appli-
ance plug according to DIN 49 547, IEC 320 (max. length 3 m). Furthermore, the cable
must adhere to all local safety regulations applicable to the specific country in which the
monitor is used.
• Device fuses should only be replaced in repair centers or by service personnel.
• Note for North America: Molded power plugs must comply with the requirements for
hospitals with respect to CSA Std. C22.2 No. 21 and UL 498.
CAUTION
Connector
Connectors may only be plugged in or removed by Service when the device is switched
off.
Prerequisite
The monitor has to be installed in the ceiling suspension, wall mount, or stand.
Procedure
1. Connect the appliance plug to the monitor power connector.
2. The power cable can be secured using a cable grip.
CuratOR LX1910
Instructions for Use, 08/2022
Connecting
5.4 Connecting the power cable
19