Eizo CuratOR LX491W Instructions For Use Manual page 32

Commissioning
6.6 Adapting the monitor using Force Mode
4. Use the "Vertical blank lines" input field to shift the top edge of the SMPTE image pixel-
exact to the top internal border of the gray/blue area.
5. Correct the values in the "Vertical Resolution" input field until the bottom internal border
of the gray/blue area is pixel-exact at the bottom edge of the SMPTE image.
6. Apply the entered data by selecting "Execute function..."
Note: Gray/blue range not visible
If no gray/blue area is visible on the left and right sides of the image, reduce the "Hori-
zontal Resolution" until the gray/blue area becomes visible. If no gray/blue area is visible
on the top and bottom sides of the image, reduce the "Vertical Resolution" until the gray/
blue area becomes visible.
Timing successfully set
The timing was set successfully. You can now exit the OSD menu. The monitor will recog-
nize the newly set timing and select it whenever connected.
Note
Only one timing can be saved in Force Mode itself.
Note
Once all settings in Force Mode have been performed, the zoom factor can be changed in
the "Geometry" menu.
32
CuratOR LX491W
Instructions for Use, 02/2018