Transmission By Auto-Dialing (Speed Dialing And Group Dialing) - Sharp MX-B350W User Manual

FACSIMILE►BASIC TRANSMISSION METHODS
TRANSMISSION BY AUTO-DIALING
(SPEED DIALING AND GROUP DIALING)
Instead of entering a full fax number with the numeric keys, you can send a fax by pressing the [SPEED] key and
entering a 3-digit number. To use an automatic dialing, the 3-digit number and name and fax number of the destination
must first be stored. See CONVENIENT DIALING METHODS (AUTO-DIALING) (page 4-6)
auto-dialing and STORING, EDITING, AND DELETING AUTO-DIAL NUMBERS (SPEED DIAL NUMBERS, AND
GROUP DIALS) (page 4-37)
Enter the 3-digit number with numeric keys.
1
• Enter the 3-digit number entered when the Speed Dial number or Group Dial was programmed.
• If you make a mistake, press the [C] key and then enter the correct number. If you enter a 3-digit number that is not
programmed in the machine, press the [C] key and then enter the correct number. If you do not know the Speed Dial
number, print out the "Speed # List" or "Group List".
► PRINTING LISTS OF PROGRAMMED INFORMATION AND SETTINGS (page
Press the [OK] key.
2
Check the destination. If correct, press the [OK] key again.
To cancel transmission
To cancel transmission while "Reading" appears or before the [READ-END] key (
key. To cancel a transmission job that is already stored, press the [FAX STATUS] key and cancel the job as explained
on Canceling a fax transmission (page
• A job number (3 digits) appears in the display with "Read End" when transmission is performed. If you make a note of
this number after performing a broadcast transmission, you can use the number to check the results of the
transmission in the transaction report or activity report.
for information on programming auto-dial destinations.
4-21).
4-12
for information on
4-45).
) is pressed, press the [C] or [CA]